Tutorial & Application/Care Tips

    Our lashes are expertly designed for quick and easy application. That said, like any makeup technique, they may take a little practice at first. But don’t worry—it’s easy to get the hang of it, and once you do, you’ll be effortlessly applying your lashes in seconds!

    Important notes:

    • When splitting the lashes into two sections, it's important to pull the lashes apart quickly. (Pulling them apart slowly can increase tension and risk loosening the magnets)
    • You’ll notice a small section at the end of each lash band without a magnet — this is designed so you can trim the lashes to perfectly fit your eye shape. If your lashes aren’t attaching properly, they may be too long. Simply use scissors to carefully trim the excess. Just make sure not to cut through any of the magnets, and your lashes will stay perfectly intact.

    Application Tips 🤍

    check_circle
    Positioning the Lashes

    Place each lash onto the according side of the applicator (the sides of the lash with the fully exposed magnets should be facing each other). Make sure the lashes are perfectly aligned with the curve of the applicator.

    check_circle
    Positioning the Applicator

    Place the upper part of the applicator onto your natural lash line. When pressing the applicator down to magnetise the lashes, lift it slightly towards you at a 45-degree angle to help the lashes sit snugly along your lash line and avoid visible spacing.

    check_circle
    Aligning the Applicator

    Before closing the applicator, ensure it is carefully positioned and aligned with the inner and outer corners of your eyes. These areas are the trickiest to align, so take extra care to position them correctly first for the best results.

    check_circle
    Releasing the Applicator

    Release the applicator gently and carefully, lifting it up and away from the eye. Avoid sliding the applicator away and  pulling on the lashes as you release, as this could shift the lashes out of position.

    check_circle
    Step 1

    Place the lashes in a small dish or container and pour a small amount of oil-free makeup remover onto a cotton pad. 

    check_circle
    Step 2

    Gently swipe the cotton pad over the lashes to remove any oil and makeup 

    check_circle
    Step 3

    Use a clean, dry towel or paper towel to blot the lashes dry. 

    How to Clean ✨

    Make sure you are being gentle and avoid rubbing or pulling the lashes. Be careful to not soak your magnetic lashes in water or other liquids, as this can damage the magnets and the lash fibres over time. Also, avoid using oil-based makeup removers, as the oil can weaken the magnetic hold of the lashes.